This site uses cookies only technical. For more information read below information on the page. Click the X to not see this written ... more

Not Translated
YAESU FTDX 5000MP

 

Roof 6 Crystal filters Extra Sharp poles
HF/50 MHz transceiver Premium FT DX 5000
Redesigned the average frequency from 9 MHz main receiver FT DX 5000 adopt precise 6 Crystal roof-pole filters [8-pole/3 kHz]
The superior dynamic range range allows for true DX 'er to obtain the best possible performance.


FTDX5000MP Limited [200 W/class A 75 W]
SM-5000 station monitor (optional)
± 0.05 ppm OCXO supplied
Filters to 300 Hz, 600 Hz crystals roof and 3 kHz supplied

SUPPLIED ACCESSORIES:
• FH-2 remote keyboard [Manipulative messages, command and selecting memory audio messages]
• MH-31B8 [mic manual]

High resolution spectrum analyzer with LBWS
Ability to monitor the activity on VFO-A. The RF bandwidth Spectrum function displays the task within a range of 25 kHz, 50 kHz, 100 kHz, 250 kHz, 500 kHz, MHz or 2.5 MHz. Select how the CTR (Center) or FIX, to limit the upper and lower frequencies and check signal levels with ATT (attenuator) or, -10 or -20 dB. The LBWS (Limited Band Width Sweep) helps reduce the bandwidth to increase the switching speed.

Roof Extra Sharp Crystal filters
New precise newly designed Crystal roof filters
The precise filters to newly designed 6 Crystal roof poles generate an excellent form factor for the VFO-A/main receiver. You can select the following values: 300 Hz, 600 Hz, 3 kHz, 6 kHz, 15 kHz and optimization for arrangements to ensure optimum performance.
Get ready to enjoy the rest of features dedicated to real amateur radio operators on current busy bands with unique and outstanding performance of the filter close to 300 Hz!

Risposta Filtri a tetto

Enjoy the exceptional and astounding range IDR 112 dB, IP3 +40 dBm

Gamma dinamica
 

TECHNOLOGY

The brand new "4 selectable IPO positions" for various types of antenna and bandwidth conditions!
The 2SC4536 (NE46134) in the design of amplifier series, gets a low distortion and noise RF amplifier, which enables the receiver to operate to the best of his ability in the most adverse operating conditions. The new IPO system selects from the front panel RF gain configuration between four conditions. Select IPO1 to feed the mixer a signal level which guarantees the best possible IP performance. Select IPO2 to eliminate RF amplification.

4 posizioni ipo

The mixer Double Quad Double Balanced-performance for the most demanding radio amateurs
Using eight 1 3SK294 Dual Gate MOS FET devices for 2 x 4 configuration for mixer

get the Double Quad Double Balanced mixer. The Double Balanced mixer using FET devices have low losses in itself does not require a gain longer than necessary by the RF amplifier, it follows the best design possible for the RF input stage.

 

mixer double quad

The unique HRDDS system from 400 MHz for high quality local oscillator
To try to improve management skills strong signals of the receiver, it is essential to have a system that produces an ultra low noise local oscillator signal of the first medium frequency extremely clean. The high C/N ratio of the system HRDDS (High Resolution Direct Digital Synthesizer) from 400 MHz, already used on the FT DX 9000, was also adopted on the series FTDX5000.

HRDDS

New type of wide range oscillator OCXO reference
The OCXO (Oven Controlled Crystal Oscillator) by 10 MHz, with a frequency stability at the top of its category, with the order of ± 0.05 ppm over a range of temperatures between -10° C and +60° C operates as the main reference for the oscillator FTDX5000MP.

imd

RF filter variable (VRF)-For frequencies from 1.8 to 28 MHz
To ensure the protection of RF stages, and the two stadiums MF, the filtering system of the input stage uses a combination of 15 fixed Bandpass Filters and unique preselector VRF Yaesu. These two systems of RF filters protect the first stages of the receiver from the overload caused by strong out-of-band signals. The VRF system in high Q has a much lower bandwidth than the fixed Bandpass Filters and is made using high permeability toroidal windings that produce optimum suppression of tuning steps 62 transmission interference or commercial services.

Filtro RF variabile

Risposta frequenze VRF e BPF

Digital signal processing system from 32-bit floating point MF
IF WIDTH/IF SHIFT interference attenuation systems worldwide
IF Shift system moves the actual passband higher or lower frequency, eliminating interference that meet outside the passband, but at the same time leaving unchanged the pitch of the incoming signal and the width of the passband MF. The reception can also be enhanced by choosing to restrict the bandwidth of the IF function WIDTH and then varying the passband through IF SHIFT.

Sistema elaborazione segnali digitali MF

Command response to the passband CONTOUR with analog touch
The filters. incredibly effective IF DSP system, can expose characteristics of input signals that you have never heard before and some of these are not pleasant to listen to. The CONTOUR command excludes low-or high-frequency components in order to model the receiver passband differently, or to compensate for part of the average range, with continuous adjustment through the passband.

Filtro Contour

Linear design of the transmitter
High power amplifier output stage, super stable (200 W, 75 W class A-mode)
The FTDX5000MP Limited VRF150 MOS FET devices using push-pull (VDSS = 170 V, VGS = ± 40 V, PD = 300 W), operating at 50 V, adjustable bias control by the customer to ensure optimum suppression of intermodulation distortion distortion effects.

 

Stadio finale

Class A power amplifier, low distortion, cutting edge
The FTDX5000MP Limited allows operation in a mode of "class A" 75-Watt output, exploiting the high bias current to generate very low intermodulation products of the transmitter; IMD 5° order or higher is typically suppressed to 65 dB or even lower values!

Classe A

Optional external µ-tuning automatic tuning completely from 28 mm
At lower bands of radio amateurs, high voltages of signals that weigh on a receiver can create noise and intermodulation effects that can cover the weaker signals that you are trying to receive. Now there are three optional tuner modules (MTU-160, MTU-80/40 and MTU-30/20) covering all amateur bands from 160 meters to 20 meters!

Sintonia

Schema di collegamento

The optional DMU-2000 data management unit will improve your performance by amateur radio!
The same information on the functioning and on stations, available with the FTDX9000 Series, can now be easily viewed by installing the optional DMU-2000 data management unit and a commercially available PC monitors (resolution 800 x 600 SVGA analog screen: 1024 x 768/XGA/, standard).

Unita

Visualizzazione panoramica frequenze
• Display of frequency overview

Spettro
• Audio spectrum/oscilloscope Display

Display World Clock
• World Clock
• Display SWR (VSWR) to frequency sweep
• Stored channel List
• The Rotator control Function

MANUAL IN ITALIAN

HERE

 

OFFICIAL WARRANTY YAESU ITALY

 

➯ Early Summer Sales

 

We are pleased to present a new offer of YAESU "Early Summer Sales".

Products covered by the offer:

-FTDX5000MP Limited

-FTDX1200

-FT-991A + SP-10 *

-FT-891

-FTM-400XDE

-FT1XDE

-FTM-3200DE


Value of refund (cashback/gift):

 

Write a review

Note: HTML is not translated!
    Bad           Good

Captcha

 

 

Click here for more information on this product.

 

 

 

 

YAESU FTDX 5000MP - SM Technology

Estimated Delivery (3-4 Working Days)

Payment methods

  • Credit card
  • Bank transfer
  • PayPal

On this Product Do not Pay SHIPPING

  • seen product: 4919
  • Brand: YAESU
  • Product Code: YAESU FTDX-5000MP
  • Availability: In Stock
  • 3,928.91€
  • Ex Tax: 3,220.42€
 

 

Clicca qui per registrare e attivare la garanzia del tuo prodotto Yaesu acquistato da noi online.

Tags: YAESU FTDX 5000MP,   Roof 6 Crystal filters Extra Sharp poles HF/50 MHz transceiver Premium FT DX 5000 Redesigned the average frequency from 9 MHz main receiver FT