statistiche web
This site uses cookies only technical. For more information read below information on the page. Click the X to not see this written ... more
Not available Remote control for yaesu transceiver cables not included

Fernsteuerung Transceiver

 

Remoteshack Controller
 

The Remoteschack Controller makes your radio now from anywhere in the world accessible. Just call the controller at home from mobile phone or from a landline. The controller receives the call. After logging in the connected radio via the DTMF phone keys can be controlled remotely. Commands are acknowledged by voice output. All functions can be controlled via ch, are also controlled from the phone, for example, Recall memory channels. Optionally, the antenna can be rotated and an antenna can switched.

Remoteshack is very easy to set up:
The controller is connected to the pre-configured wiring harness to the radio. From the controller cable is routed to the existing telephone terminals. "The radio is still the CAT baud rate and the NF-volume set, so that the configuration is already completed. The setup is done in less than 20 minutes ... most of the time will require for laying the cable to the phone line!

On the other side, no additional hardware is required other than the already existing phone! The thus achieved mobility opens up new possibilities. Scan the frequencies of Expedition from the supermarket, or use your home station out of the car with a headset on the dryer while driving.

Remoteshack is also ideal for remote locations where no or slow internet connection is and therefore fail the standard remote method.
If there is high speed internet available at the remote site can also be controlled via Skype connection.

As an option, there is a ' standard ' hand microphone with DTMF connector suitable for the normal smartphones. QSOS can then be performed as usual with PTT button. A small included interface handles the generation of DTMF tones to control. In conjunction with an IC-7000 can display a smartphone even the display of the radio!

Phone fees apply of course. Who has a (mobile) telephone flat rate must not worry about the costs.

A little note from us: Smartphones as well as some "regular" phones have a very small, built-in speaker. If you use the internal speaker of the phone it's sounds poor. We therefore recommend to use the client interface RB-CMI-1, as you can see there on the photo how to attach to speakers or headphones.

 

How works the Remoteshack Controller?

After the controller is connected to the telephone line and the transceiver, everything is set, it can go on.
You simply call the phone number to which the controller is connected. It answers and then prompted to enter a 4-digit code on it. After entering the correct code, the controller says the frequency and you hear the receiver of the transceiver. Using the supplied command list you can now control via the telephone the transceiver.

The operation via Skype is similar. The Remoteshack controller is connected via 2 cable to the sound card of the computer on which Skype is running. Skype must be set to auto answer to the caller. Now, when a connection is made, the controller responds like a telephone call and can used similar.

The highlight of a connection over Skype is that you can put a webcam in front of the transceiver, the image is transmitted over Skype. If the camera is focused on the transceiver display, so you can read the settings and the frequency.

Cable for Yaesu FT-950/2000, FT-DX1200/3000/5000


GOOGLE TRANSLATE

Remoteshack Controller
The Remoteschack controller makes the radio now from anywhere in the world accessible. Just call the Comptroller home from your phone or from a landline. The controller receives the call. After accessing the radio connected via telephone DTMF keys can be controlled remotely. The commands are recognized by the speech playback. All functions can be controlled through the CAT, are controlled by phone, for example, invoke memory channels. Optionally, the antenna can be rotated and an antenna can be switched.

Remoteshack is very easy to configure:
The controller is connected to the preconfigured radio wiring. By the controller, a cable is routed to the existing telephone terminal. The radio is still speed CAT and NF-volume, so that the configuration has already been terminated. The setup was done in less than 20 minutes ... most of the time it will take for the laying of the cable into the phone line!

On the other hand, no additional hardware is required unless the phone already exists! Thus achieved mobility opens up new possibilities. Scan the frequencies of the DXpedition to supermarket, or use the home station out of the machine with a hair dryer headset while driving.

Remoteshack is also ideal for remote locations where there is no or slow internet connection and not the standard remote method then.
If there is high speed internet available at the remote site can also be controlled via Skype connection.

As an option, there is a ' standard ' hand DTMF microphone connector suitable for normal smartphone. QSO may then be performed as usual with the PTT. A small interface supplied handles generating DTMF tones to the control. In combination with an IC-7000 can display a smartphone even on the radio display!

Telephone fees apply of course. Who has a (mobile) Flat rate doesn't have to worry about costs.

A little note from us: Smartphones and some ' normal ' phones have a small, built-in speaker. If you use the phone's speaker sounds poor. We recommend that you use the client interface RB-CMI-1, as you can see on the photos how to attach a speakers or headphones.



How does the Remoteshack controller?

After the controller is connected to the phone line and the transceiver, everything is set up, you can go ahead.
Simply call the telephone number that is connected to the controller. Answers are then prompted to enter a 4-digit code on it. After entering the correct code, the checker says that the frequency and feels the receiver of the transceiver. Using the list of commands supplied you can now check by phone the transceiver.

The operation with Skype is similar. The Remoteshack controller is connected via 2 cable to the sound card of the computer running Skype. Skype answering machine must be set to the caller. Now, when a connection is made, the controller reacts like a phone call, and can be used like.

The culminating point of a link with Skype is that you can put a webcam in front of the transceiver, the image is transmitted on Skype. If the camera is focused on the transceiver display, so you can read the settings and frequency.

Write a review

Note: HTML is not translated!
    Bad           Good

Captcha

Remote control for yaesu transceiver cables not included

WhatsApp +393331832811

Estimated Delivery (3-4 Working Days)

  • Brand: wimo
  • Product Code: RBC-212-KN1
  • Availability: Not available
  • 425,79€
  • Ex Tax: 349,01€

Available Options